Modbus & Serial Output Transmitter for Load Cell or Microvolt Input

Powers up to four 350 ohm load cells in parallel. DIN Rail mounted. Digitally programmable. Exceptional accuracy at high update rates.
Navigation: Home > Modbus transmitters
Serial ASCII or Modbus Output Transmitter, Load Cell or Microvolt Input
Key Features
  • 20, 50, 100, 250 & 500 mV full-scale ranges
  • 4 or 6-wire hookup to avoid supply and lead resistance effects
  • Digital span adjust from 0 to ±99,999
  • Digital zero adjust from -99,999 to +99,999
  • Accuracy to 0.01% of full scale.
  • RS232 or RS485 serial communications, half or full duplex, isolated
  • Transmits power factor from 1.000 to 0.000 with sinusoidal signals
  • Modbus RTU, Modbus ASCII or Laurel ASCII protocol
  • Output update rate to 60/sec
  • Easy setup with PC-based Instrument Setup Software
  • DIN rail mount housing only 22.5 mm wide
Ordering Guide
Laureate Modbus & Serial Output Transmitter for Load Cell or Microvolt Input
Click on the radio buttons to build a model number with pricing as shown below.

Configured model number LTM2000WM
Configured price per model $295
Quantity 1
Extended price $295
Quantity
Transmitter
Type
LTM Laureate Transmitter, Modbus or Laurel ASCII Protocol
$235
Main
Board
2 Standard Main Board
4 Extended Main Board
$0
$40
Note: Extended allows custom curve linearization and rate from successive readings.
Power
0 Isolated 85-264 Vac
1 Isolated 12-32 Vac or 10-48 Vdc
$0
$30
Relay
Output
0 None
2 Isolated Dual Solid State Relays
$0
$0
Analog Output
0 None
1 4-20 mA, 0-10V
$0
$0
Signal
Input		 Load Cells (6-wire ratio)
WM Field scalable. Default scaling is 0-20 mV in = 4-20 mA out
WM1 Custom Scaling. Specify min input, min reading; max input, max
        reading.
$60
$60
Accessories
CBL04 RS-232 cable, LTM to computer or USB adapter
CBL02 USB to RS-232 cable adapter
$19
$39

feedback