LTS6 Serial-to-Analog DIN Rail Transmitter

Converts serial input data to a scaled analog output signal.

Navigation: Home > 4-20 mA Transmitters

Laurel TS6 Serial-to-Analog DIN Rail Transmitter

Standard Features

Converts serial input data to a scaled analog output signal.
Operates in slave mode with RS-232 or RS-485 serial data input
Four protocols: Modbus RTU, Modbus ASCII, Laurel ASCII, ASCII characters
Able to retrieve data from long character strings
Data rates from 300 to 19,200 bps
Isolated 4-20 mA, 0-20 mA, or 0-10V transmitter output, user selectable
Output resolution: 0.0015% of span (16 bits), accuracy : ±0.02% of span
Update rate to 60/sec
Detachable screw-clamp connectors
Easy setup with PC-based Instrument Setup Software
Dual solid state relays for alarm or control, isolated
Universal AC power, 85-264 Vac

Options

Low voltage power, 10-48 Vdc or 12-32 Vac

Laureate LTS6 Serial Input, Analog Output, DIN Rail Transmitter

Serial Communications (standard)
Signal Types Data Rates Output Isolation Serial Protocols Modbus Modes Modbus Compliance Digital Addressing	RS232 or RS485 (half or full duplex) 300, 600, 1200, 2400, 4800, 9600, 19200 baud 250V rms working, 2.3 kV rms per 1 min test Modbus RTU, Modbus ASCII, Laurel ASCII RTU or ASCII Modbus over Serial Line Specification V1.0 (2002) 247 Modbus addresses. Up to 32 devices on an RS485 line without a repeater.
Analog Output (standard)
Output Levels Compliance, 4-20 mA Compliance, 0-10V Output Resolution Output Accuracy Output Update Rate Output Isolation	4-20 mA, 0-20 mA, 0-10 Vdc (selectable) 10V ( 0-500Ω load ) 2 mA ( 5 kΩ load ) 16 bits (65,536 steps) 0.02% of output span Determined by input data rate 250V rms working, 2.3 kV rms per 1 minute test
Dual Relay Output (standard)
Relay Type Load Rating	Two solid state relays, SPST, normally open, Form A 130 mA at 140 Vac or 180 Vdc
Power Input
Standard Power Low Power Option Power Frequency Power Isolation Power Consumption	85-264 Vac or 90-300 Vdc (DC operation not UL approved) 10-48 Vdc or 12-32 Vac DC or 47-63 Hz 250V rms working, 2.3 kV rms per 1 min test 2W typical, 3W with max excitation output
Mechanical
Dimensions Mounting Electrical Connections	129 x 104 x 22.5 mm case 35 mm rail per DIN EN 50022 Plug-in screw-clamp connectors
Environmental
Operating Temperature Storage Temperature Relative Humidity Cooling Required	0°C to 55°C -40°C to 85°C 95% at 40°C, non-condensing Mount transmitters with ventilation holes at top and bottom. Leave 6 mm (1/4") between transmitters, or force air with a fan.